Robert Bosch Tool Corp. Recalls Hammer Drills Due to Risk of Injury
CPSC Recall Notice
Source: U.S. Consumer Product Safety Commission (CPSC) — official agency notice for recall CPSC-4330.
The recalled hammer drill is blue with "BOSCH" printed on the side. The model number 1191VSR can be located on the product nameplate mounted on the side of the motor. The product's packaging will be marked as 1191VSRK (the "K" indicates that the hammer drill was packaged with a case in a kit). Only drills with a serial number that begins with "7" are included in the recall.
Corrective Action (per CPSC)
Source: U.S. Consumer Product Safety Commission (CPSC) — official agency notice for recall CPSC-4330.
Consumers should stop using the recalled hammer drill immediately and contact the firm for a free repair.
✅ What you should do
- Stop using the product if you own it.
- Check the model number, lot code, or sell-by date against the recall notice above.
- Contact Menards And Other Hardware Retailers And Industrial Distributors Nationwide From July 2007 Through April 2008 For About $100. or the retailer where you bought it for a refund, replacement, or repair.
- For the most current official instructions, visit the CPSC recall page.
- If you've been hurt by this product, report the incident to CPSC.
Consumer Contact (per CPSC)
Source: U.S. Consumer Product Safety Commission (CPSC) — official agency notice for recall CPSC-4330.
For additional information, contact the Robert Bosch Tool Corp. toll-free at (877) 472-0007 between 7 a.m. and 7 p.m. CT Monday through Friday, or visit the firm's Web site at www.boschtools.com
About the U.S. Consumer Product Safety Commission
The CPSC protects consumers from injuries and deaths from thousands of types of consumer products — toys, furniture, electronics, appliances, and more.
Visit CPSC.gov →📣 Report an unsafe product to the CPSC
If you own this product and experienced a defect, near-miss, or injury, file a report with the CPSC. Consumer reports are the primary signal the agency uses to identify defect patterns and trigger future recalls. Your report is free, takes about 10 minutes, and can stay anonymous to the manufacturer.
Menards And Other Hardware Retailers And Industrial Distributors Nationwide From July 2007 Through April 2008 For About $100. Recall FAQ
Menards And Other Hardware Retailers And Industrial Distributors Nationwide From July 2007 Through April 2008 For About $100. is the subject of a tools recall: Robert Bosch Tool Corp. Recalls Hammer Drills Due to Risk of Injury. The notice was published on June 12, 2008 by the U.S. Consumer Product Safety Commission (CPSC). Approximately 9,700 units are potentially affected.